Each Bed Bumper for Big Kids is made by hand in the USA and available in a variety of fabric patterns.  At approximately 68 inches in length, they are made to fit almost any size bed, from toddler beds to full size beds.  They safely Velcro to the wall that runs alongside a bed using three small Velcro strips, allowing them to be removable and washable. 

The bumper's unique features include a soft cushioning effect to prevent a child from bumping into their wall during sleep-time tossing and turning.  Additionally, they may help to buffer a chilly wall.

Add to any child's existing bedroom decor or shop our great kids comforter sets to complete the look in their room and add to their complete comfort.

Bumper Dimensions:
Each bed bumper measures approximately 6' in length and 18" in width.  They average about 1” in thickness.

Superior Materials Include:
100% cotton fabrics, flannel where labeled
100% polyester fill Non-allergenic

Safety Warning:
This bed bumper for big kids is not intended for babies.  It is also not intended for use in conjunction with a crib.  This bed bumper, as with any child’s bedding, should only be used when a child is no longer at risk for SIDS due to suffocation.  The child should also already be accustomed to other types of bedding, such as blankets, sheets and pillows.
Our materials are not flame retardant, so keep away from any open flame.

Disclaimer:
My Doudou™ Bed Bumpers for Big Kids are not guaranteed to prevent injury.  When used correctly, they are designed to reduce the risk of injury caused during normal sleep-time tossing and turning.  They are also not guaranteed to keep your child warm.  They acts as a buffer between your child and a cold wall, reducing the effects of a chilly wall.

Mounting Instructions:
My Doudou™ Bed Bumper for Big Kids should be used on non-porous, clean and dry painted walls.  Position the bed bumper on the wall, alongside the bed, where you would like it to remain.  The bottom of the bed bumper should be partially tucked between the bed and the wall.  Remove the adhesive backing from the Velcro™ that is attached to the bed bumper.  Press the adhesive strips firmly onto the wall so that the bed bumper is horizontally level with the bed.  Wait 1 hour for adhesive to set.  Adhesive reaches maximum strength in 24 hours. 
Note:  Moving the fasteners from original location will weaken sticking power and may mark painted surfaces. 

Moving or Removing Adhesive Velcro Strips from Painted Wall:
The longer that your Velcro strips are on the wall, the stronger the bond will be.  To completely ensure proper removal of adhesive Velcro strips without damage to painted walls, please follow these steps…
Step 1:
Gently position the blade of a putty knife at the edge of the tape and, using light force, attempt to slide the knife under the tape without pulling up any paint or wallboard.
Step 2:
If you experience difficulty getting the knife underneath the tape, stop and get a blow-dryer.
Step 3:
Heat the tape with the blow-dryer, alternating between low and high heat, and stopping occasionally to work at the tape with the knife. The heat should make the tape soft and easy to remove.
Step 4:
Clean the sticky residue that remains with an adhesive remover such as Goof Off or Un-Du, using a dry rag. A few careful strokes with the adhesive remover and you're finished!

Care Instructions:
Please remember to remove adhesive Velcro™ fasteners prior to first wash. 
My Doudou™ Bed Bumper for Big Kids is machine washable in cold water with like colors.  Non-chlorine bleach only.  It can be tumbled dry on low heat.

Thank you for shopping with us!